＞2.4GHz射频收发器
＞低功耗蓝牙模式下的接收灵敏度-93dBm
＞支持1Mbps，2Mbps，250kbps的速率
＞TX发射功率从-20～+4dBm以4dB为间隔
＞RX和TX(0dBm)的峰值电流分别为9.7mA和8mA(0dBm) @DC/DC
＞ARM Cortex M0 32位处理器
＞在FLASH中运行时功耗为275uA/MHz
＞在RAM中运行时功耗为150uA/MHz
＞单线调试接口（SWD）
＞支持并行多协议
＞支持BLE、私有2.4G多种协议
＞灵活的电源管理
＞支持电压范围1.8～3.6V
＞0.6uA @3V OFF关闭模式
＞2.6uA @3V ON模式带，系统空闲
＞256kB或128kB flash/16kB或32kB RAM
＞丰富的外设及接口
＞8个可配置的ADC通道
＞温度传感器
＞31个GPIO
＞主从模式的SPI接口
＞主模式的I2C接口
＞可编程外设接口(PPI)
＞正交解码器（QDEC）
＞UART(CTS/RTS)
＞RTC
＞AES硬件加密

● 2.4 GHz transceiver
● -93 dBm sensitivity in Bluetooth  low energy mode
● 250 kbps, 1 Mbps, 2 Mbps supported data rates
● TX Power -20 to +4 dBm in 4 dB steps
● TX Power -30 dBm Whisper mode
● 13 mA peak RX, 10.5 mA peak TX (0 dBm)
● 9.7 mA peak RX, 8 mA peak TX (0 dBm) with DC/DC
● RSSI (1 dB resolution)
● ARM  Cortex™-M0 32 bit processor
● 275 μA/MHz running from flash memory
● 150 μA/MHz running from RAM
● Serial Wire Debug (SWD)
● S100 series SoftDevice ready
● Memory
● 256 kB or 128 kB embedded flash program memory
● 16 kB or 32 kB RAM
● On-air compatibility with nRF24L series
● Flexible Power Management
● Supply voltage range 1.8 V to 3.6 V
● 4.2 μs wake-up using 16 MHz RCOSC
● 0.6 μA at 3 V OFF mode
● 1.2 μA at 3 V in OFF mode + 1 region RAM retention
● 2.6 μA at 3 V ON mode, all blocks IDLE
● 8/9/10 bit ADC - 8 configurable channels
● 31 General Purpose I/O Pins
● One 32 bit and two 16 bit timers with counter mode
● SPI Master/Slave
● Low power comparator
● Temperature sensor
● Two-wire Master (I2C compatible)
● UART (CTS/RTS)
● CPU independent Programmable Peripheral Interconnect (PPI)
● Quadrature Decoder (QDEC)
● AES HW encryption
● Real Timer Counter (RTC)